SPECIFICATIONS FOR SEAMLESS BRASS TUBES AS PER ASTM- B ITEM NO. 1 TO 4: Nominal composition: Cu – 63% and Zn – 37% (Copper alloy UNS. ASTM B/BM Standard Specification for Seamless Brass Tube. standard by ASTM International, 10/01/ View all product details. Most Recent. ASTM B Standard Specification for Seamless Brass Tube. standard by ASTM International, 10/01/ View all product details. Most Recent. Track It.
|Published (Last):||23 November 2008|
|PDF File Size:||10.75 Mb|
|ePub File Size:||6.54 Mb|
|Price:||Free* [*Free Regsitration Required]|
The tubes shall undergo mechanical tests such as tension test, Rockwell hardness test, and expansion test in order to determine certain properties such as tensile strength and hardness.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
The tempers of drawn tube shall be designated as light-drawn H55drawn H58and hard-drawn H Caution should be taken when handling mercury and mercury containing products. Ten atm are specified having the following nominal compositions:. For atm combination of diameter and wall thickness not covered under hard-drawn temper, the values given for drawn temper shall be used.
Light-drawn bending temper is used only when a tube of some stiffness but yet satm of being bent is needed. Combining values from the two systems may result in non-conformance with the standard.
Specs ASTM B135
Historical Version s – view previous versions of standard. C, and UNS No.
A mercury nitrate test shall be done to detect and remove mercury vapor. Link to Active This aatm will always route to the current Active version of the standard.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. ASTM does not aztm any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. This abstract is a brief summary of the referenced standard.
ASTM B / BM – 17 Standard Specification for Seamless Brass Tube
Nondestructive tests such as eddy-current test, hydrostatic test, and pneumatic test shall be done as well. Drawn temper is for general purposes and is most commonly used v135 there is no specific requirement for high strength on the one hand or for bending qualities on the other.
The tempers of annealed qstm shall be designated as light anneal O50 and soft anneal O Ten alloys are specified having the following nominal compositions: Hard-drawn temper is used only where there is need for a tube as strong as is commercially feasible for the sizes zstm.
Mercury, or its vapor, has been demonstrated to be hazardous to health and corrosive to materials. This specification covers seamless round and rectangular including square copper alloy tube in straight lengths. The following copper alloys are specified and classified according to their nominal compositions: